GLUING AND SOLES ATTACHING

1. Should be care of its accuracy scribing board.Using pressure is about 2-3kg/cm.
2. Should be removed its surface of leather based on the scribed circular measure in grinding process.
3. Should be pasted by priming liquid of the attaching part of outsole.
4. Its heating temperature should be 100℃ ± 5℃
5. The operators should be careful of putting cement on both upper and sole in balance and properly, Do not make dirty on upper and soles.
6. When lamination sole on the upper, the operator must control the sole is fittingly attached to the upper can't make any crooked, and try to press the edge as tight ass possible.
7. When pressing the shoes, the operator should properly control the 20-40 kg.cm and (5-8 sec.) of the press machine.
8. After pressing the soles.

   For the vulcanizing shoe: collect the shoes to the steam boiler for rubber vulcanizing.
   For cool-cementing shoes: collect shoes to the cooling equipment.

9. The operator can not take off the lasts from the shoes before the shoes get cooling stabilized.